MICROPROCESSOR SYSTEMS 2 Programing Tasks
. Subject: MICROPROCESSOR SYSTEMS..
Task 1: Real-time clock (30 marks)
The delay function as used in the
workshops is limited because it depends on approximate
timing based on how long the processortakes to execute the NOP instruction, and the
limitations ofthe size of an integer means that the maximum delay will be approximately 65 seconds. Furthermore, the processor
cannot do anything else while the delay is going on, and
any interrupts run during the delay will cause the delay to be longerthan intended.
The Atmel ATmega168 does provide the facility to maintain more accurate and longer timings through the use ofthe crystal
oscillator and the timer/counter circuitry in the
Yourtask is to work out howto use these components so that programs can be written to
accurately trigger events at least up to 1 hour after a timer is set. The function should allow forthe timer
interval to be set in minutes and seconds.
Your solution should include the following:
1. Overall description ofthe principles of operation
of your solution
2. Description of all timer/counters, registers, and interrupts used and theirfunction 3. Details of all configuration
information to get the processorto perform this function
(e.g. what needs to be written to different configuration registers, including
particular bits are set or cleared)
4. Description ofthe overall algorithm(s) to implement the function
Note: This can be in the form
of pseudocode. Code fragments (lines of code) can be
used to demonstrate where appropriate.
Note: You do NOT have to write the whole program
Task 2: Interfacing a 7-segment LED display (20 marks)
7-segment LED displays are commonly used in microcontroller
applications. The datasheet
forthe Avago HDSP-5601 LED display is attached. Yourtask is to design an interface between the Atmel
ATmega168 microcontroller and this particular display.
1. Referto the datasheet, pick out all the relevant interface data (this is a very important
practical skill!) and clearly list them.
Note: Make sure you get details ofthe right model.
2. Produce a circuit diagram with
details of all elements required to allowthe processor
to drive this particular LED display properly. You should provide copies of
datasheets for any elements you may choose to include in your design (except passive elements such as resistors and capacitors).
Describe how your circuit elements aIDress the interfacing requirements. Please ensure that you consider both the Atmega168 and LED display
specifications, and justify any decisions made, including any calculations if required. 4. Write a C subroutine that will
enable the display ofthe digits 0? to 9? and characters
a to f (for hex numbers) on the LED display (specified by a
parameter passed to
the subroutine). Note: Assume you are using the NerdKit as in the labs.ORDER THIS ESSAY HERE NOW AND GET A DISCOUNT !!!
Hi there! Click one of our representatives below and we will get back to you as soon as possible.